Speakerphone
Note: If you are uncertain whether your voice terminal is set for the Speaker
Use the following procedures if your voice terminal is set for the Speakerphone (speak and listen) feature.
For directions on using the Reset Speakerphone feature, see "Reset Speakerphone" in this section.
To place/answer a call without lifting the handset, or to use speakerphone with any feature
1Press [ Speaker ]
●Red light next to [ Speaker ] goes on steadily
2Place or answer call, or access selected feature
3Adjust speakerphone volume if necessary
●To raise the volume, press the right half of the Volume control button labeled [ ∧ ] ;
to lower the volume, press the left half of the Volume control button labeled [ ∨ ]
●If you have a display, it shows
SPEAKER L>>>>> | H |
|
|
(There are eight possible volume settings. On the display, one arrow is the lowest setting, and eight arrows is the highest setting)
Note: The Volume control does not affect an external speakerphone attached to your voice terminal.
To prevent the other | Note: If the Speakerphone feature is not active, the |
party from hearing you | Mute feature turns off the microphone associated with |
| the handset (not the speakerphone). However, if the |
| speakerphone is active and the handset is not active, |
| then the Mute feature turns off the microphone |
| associated with the speakerphone (not the handset). |
| 1 Press [ Mute ] |
| ● Red light goes on and other party cannot hear |
| you |
| 2 Press [ Mute ] again to resume talking to party |
| ● Red light goes off and other party can hear you |
| again |
36
