AT&T 944 user manual Timer, Pause, Switching Modes

TELEPHONE OPERATION

To make a call, press and release hor press the desired LINE button and then press h. The HEADSET light goes on. Wait for a dial tone, then dial the call.

To answer a call, press h. Press hagain to end the call.

NOTE: If speakerphone is programmed as the default mode (See “Set Automatic Audio Mode” in FEATURE SET UP), you must press h to activate the headset.

Switching Modes

To switch from handset to headset or speakerphone, press hor K, then replace the handset (for headset, headset must be plugged in).

To switch from speakerphone to handset, lift the handset. (Do not press Kor the call will be disconnected.)

To switch from headset to handset (when handset is in the cradle),

lift the handset.

To switch from headset to handset (when handset is off-hook), press

hagain.

To switch from headset to speakerphone (when handset is in the cradle), press K.

To switch from headset to speakerphone (when handset is off-hook), press Kand replace the handset.

To switch from speakerphone to headset, insert the headset plug into the jack, and press h.

To override automatic line selection, press and release a LINE button (this activates the speakerphone or headset, whichever is programmed as the default mode).

Timer

When you make or answer a call, the timer automatically starts. The screen displays the elapsed time in minutes and seconds for the first hour (up to 59:59 ) and then begins again. The timer stops automatically when you hang up and the recorded time is displayed for about 10 seconds.

The timer also stops when you place a call on hold and resets when you release hold.

Pause

While dialing a call press Pwhere you want to insert a three-second pause in the dialing sequence. This is useful if you are dialing a long-distance access code and the long-distance carrier requires a pause between the access code and the telephone number.

21