AT&T E5654B Charging, Light is off, Light on, Telephone base, Is flashing, There is no dial, Tone

Appendix

Troubleshooting

Problem	Suggestion
The CHARGING	• Clean the charging contacts on the cordless handset(s) and telephone
light is off	base each month using a pencil eraser or a dry non-abrasive fabric.
	• Make sure the power adapter and telephone line cords are plugged in
	correctly and securely.
	• Unplug the power adapter. Wait for 15 seconds before plugging it back
	in. Allow up to one minute for the cordless handset and telephone base
	to synchronize.
	• The telephone might be malfunctioning. Please refer to the Limited
	Warranty section of this user's manual for further instruction.
The CHARGING	• This is a signal that the battery is very low, completely depleted, or
light on the	when there is no electrical contact between the battery and the tele-
telephone base	phone base.
is flashing	• Ensure the connector of the battery is securely plugged into the hand-
	set and place the handset in the telephone base for charging.
There is no dial	• First, try all the above suggestions.
tone	• Move the cordless handset closer to the telephone base. It might be
	out of range.
	• The telephone line cord might be malfunctioning. Try installing a new
	telephone line cord.
	• Disconnect the telephone base from the telephone jack and connect
	a different telephone. If there is no dial tone on this telephone either,
	the problem is in the wiring or the local service. Contact the local tele-
	phone company.

50