Installation | ATTO Technology FastStream VT, 5300 guide

A bicolor Ready/Fault LED is lighted green to indicate ready, lighted yellow to show a faulted condition, and off indicates not ready.

SCSI ports: A green LED on each port indicates activity if is lit.

Exhibit 1.1-1 FastStream VT 5300 front panel LEDs.

Exhibit 1.1-2 Connectors, LEDs and power receptacle

Fibre Channel port: bicolor LED indicates FC speed. If it is off, speed is 1-Gb; if it is green, 2-Gb, and yellow indicates 4-Gb FC. A separate green LED indicates activity if it is lit, no activity if it is off.

4 Installation

Page 9

Image 9

ATTO Technology FastStream VT, 5300 operation manual Installation

Contents

FastStream VT Page Page Contents Appendix E Warranty, contact information Xxi Update storage and firmwareModify storage Interface options Virtual Tape features Hardware featuresBackup and restore features Management and control features Gb FC Switch GbE Switch Ethernet Fibre ChannelGbE network Physical attributes Installation Unpack the packing box verify contents InstallationInstall the FastStream Install Windows drivers Click on Launch Browser Begin initial configuration Configure Virtual Tape Use custom initial setup Use quick initial configuration Click on the Add/Remove Hot Spares button Use Hot Spare devices Enable/Disable Write Protection page appears Click in the Enable/Disable Write Protection buttonSecure data through Write Protection Move Virtual Tape Cartridges Customize the username, password Change system configurationsOptional changes to system parameters Advanced CLI Changes to other parameters may be made using the Advanced Monitor VTL Monitor storage and diagnose configurations Configuration Display Health and Status MonitorPhone home E-mail messages Click the Set up Error Notification button ConfigurationMeasure drive performance Verify storage Scan drive surfacesClick the Initialize and Verify button Select Verify Only Modify storage Initialize and verify drivesAdd drives to a RAID Group Add or remove Hot Spares Rebuild RAID GroupsSelect Rebuild RAID Groups Select the Add/Remove Hot Spares button Add a VTL from another FastStream VTL Delete a VTLClick in the Delete Virtual Tape Library button Move Virtual Tape Cartridges Remove stale VTL configuration data Update storage and firmwareUpdate firmware Preliminary steps Use the RS-232 serial link Use FTP over EthernetSend File Click Send File Interface options Use the serial portType FastStream VT 5300 in the New Connection dialog box Enter Use Telnet Appendix a Cabling Scsi cablingCable types Cable length Fibre Channel connections Jbod Just a Bunch of Disks Appendix B Designing RAID groupsRAID Level Disk Iv Appendix Appendix C CLI provides an ASCII-based interface Symbol Indicates Mp1 CLI error messages CLI summary Command Default Example Viii Appendix Sntp CLI command explanations DHCPFixedDelay DefaultInterleaveDriveTestConfig DumpConfig EmailNotifyAddress EmailPasswordEmailServerAddress EmailUsername FCDataRate FCPortErrorsFCHard FCHardAddress IPGateway PasswordIPSubnetMask IsReserved ResetFCPortErrors RAIDCommandTimeoutRestoreConfiguration RGCancelAddStorage RGDisplay RGWaitTimeoutRGHaltConversion RGHaltRebuild SCSIPortReset SaveConfigurationSCSIPortResetOnStartup RMStatus SerialPortEcho SerialPortBaudRateSNTPServer TailEventLog Further results of FCC Testing Appendix D Standards and compliancesThis equipment generates, uses, and can radiate radio Declaration of Conformity European Standards Appendix E Warranty, contact information Manufacturer limited warrantyContact Atto Technology, Inc Xxii Appendix