ATTO Technology 5300 FCDataRate, FCHardAddress, FCPortErrors, FCPortList, FCSCSIBusyStatus

FCDataRate

Specifies the rate the FastStream uses, 1 Gigabit/sec., 2 Gigabit/sec. 4 Gigabit/sec. or auto negotiate.

Default: auto

set FCDataRate [fp] [1Gb 2Gb 4Gb auto] Requires a SaveConfiguration command get FCDataRate

FCHard

Used to enable or disable FC hard address assignment. Under soft addressing, the FastStream loop address is assigned during loop initialization.If you enable hard addressing use FCHardAddress (described below).

Default: disabled

set FCHard [enabled disabled] Requires a SaveConfiguration command get FCHard

FCHardAddress

Sets/displays the value used as the FC-AL hard address. This hexadecimal value represents the address the FastStream tries to use if hard addressing is enabled. When an address is not set, the current value is displayed. The valid range of values is 0 through 125.

Default fp1=3; fp2=4

set FCHard Address [fp [address]] Requires a SaveConfiguration command get FCHardAddress [fp]

FCPortErrors

FCPortErrors displays the number of Fibre Channel errors that have occurred since the last reboot/power-on or ResetFCPortErrors.

get FCPortErrors

FCPortList

Returns a list of available FC ports and their current status. Valid status values are OK and Failed.

FCPortList

FCSCSIBusyStatus

Chooses to report BUSY or QUEUE FULL when a unit is unable to accept a SCSI command.

Default: busy

set FCSCSIBusyStatus [busy qfull] Requires a SaveConfiguration command get FCSCSIBusyStatus

xiii

FCWWName

Reports the Word Wide Name (WWN) of the FC interface. Each FC port has an individual and unique WWN. The least significant 3 bytes of the WWN are used as the Ethernet MAC address. The lower nibble of the highest byte designates the port number.

get FCWWN [fp]

FirmwareRestart

Resets and reinitializes the unit firmware. Use the forced option to override any CLI reservations held by other sessions.

FirmwareRestart <forced>

Help

Displays a list of available commands. If command name is specified, displays detailed command-specific information.

Help <command name>

HSAdd

Assigns a Block Device to the Hot Spare pool.

HSAdd [BlockDevID]

HSDisplay

Lists all devices in the Hot Spare pool.

HSDisplay

HSRemove

Removes a Block Device from the Hot Spare pool

HSRemove [BlockDevID]

IdentifyBridge

Enabling this option causes the front panel Ready LED of the FastStream to blink until the parameter is disabled.

Default: disabled

set IdentifyBridge [enabled disabled] get IdentifyBridge

Info

Displays version numbers and other production information for key components.

Info

IPAddress

Regulates the current FastStream IP address.If IPDHCP is enabled (see below), get command reports current IP address assigned by DHCP server. Setting this value always modifies the internal NVRAM value of the IP Address, whether or not a SaveConfiguration is performed.

Default IP Address: 10.0.0.1

set IPAddress [mp1] xxx.xxx.xxx.xxx get IPAddress [mp1]

ATTO Technology Inc. FastStream VT 5300 Installation and Operation Manual