Command | Default | Example |
|
|
|
Voltage |
| get voltage |
|
|
|
WrapEventLog | enabled | set wrapeventlog disabled |
|
|
|
zModem |
| zmodem receive |
|
|
|
CLI command explanations
Command Line Interface commands are listed alphabetically with explanations of what they are used for, their defaults and syntax.
CAUTION
Do not use CLI unless you are directed to by an ATTO technician.
Changing parameters may cause loss of data and/or disruption to performance and reliability of the FastStream.
The FastStream VT 5300 GUI is the preferred method to operate and manage the FastStream VT 5300. Refer to Interface options on page 23 for details
AutoMap
Automap automatically maps a subset of target devices visible to the firmware. All previous maps are deleted.
AutoMap
AutoResume
Enables/disables the automatic continue feature for interrupted rebuild, erase and write pattern operations at startup. If AutoResume is enabled, all interrupted rebuild, erase and write pattern operations are continued at startup. Optional parameter GroupName specifies the RAID Group whose Restart features to be set. If no GroupName is specified, all existing RAID Groups are affected.
Default: all disabled
set AutoResume [Rebuild Erase WritePattern all] [enabled disabled] <GroupName>
BlockDevClean
Removes any ATTO configuration data from the block device with the specified BlockDevID. BlockDevID is the index of a block device provided by the BlockDevScan CLI command.
BlockDevClean [BlockDevID]
Date
Regulates the current date for this unit. The date range is 1/1/2000 to 12/31/2099.
BlockDevIdentify
Causes the I/O LED of the drive to illuminate for one minute if it is accessible through the SCSI port
CAUTION
The BlockDevIdentify command is intended for diagnostic purposes only. Executing this command may adversely impact the performance and throughput of the FastStream for the time that the LED is illuminated.
BlockDevIdentify <Groupname> [BlockDevID MberIdx]
BlockDevIDStop
Turns off the IO LED of a previously identified disk drive.
BlockDevIDStop
BlockDevScan
Lists all currently connected physical drives along with any potential RAID Group association. Each block device listed is assigned a unique index at the time of the scan to identify drives for other CLI operations.
BlockDevScan
BridgeModel
Reports model information about the FastStream.
get BridgeModel
BridgeName
Specifies the
Default: ““
set BridgeName [value]
Requires a SaveConfiguration command get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries are recorded until ClearEventLog has completed.
ClearEventLog
Default: 01/01/2000
set Date [MM] [DD] [YYYY] get Date
x Appendix
