3
Installing a New G700 with an S8300
Configure the G700 Media Gateway
Installation and Upgrades for G700 and S8300 143
December 2003
Type show mgc to display the list of available servers and their IP addresses.
For example:
Show Call Controller Status Screen
The Gateway will have registered with the primary controller, if present. If the primary controller
is running and has been administered properly, the Registered field says YES and the H248 Link
Status says UP. If the controller is not running, the Registered field says NO and the H248 Link
Status says DOWN.
Set the LSP Transition Points
You must set the time that the G700 searches, in the event of a network problem, for primary controllers
(for example, additional CLAN connections) with which to register. After this search time has elapsed,
the G700 will search for an LSP with which to register. You must also set the total time the G700 searches
for either a primary controller and an LSP, after which the G700 resets. And finally, you must define how
many primary controllers, from 1 to 4, are in the controller list you just defined.
1At the MG-001-1(configure)# prompt, type set mgp reset-times primary-search <search-time>
where <search-time> is the time in minutes that the G700 searches for a primary controller
before looking for an LSP. The range is from 1 to 60.
2At the MG-001-1(configure)# prompt, type set mgp reset-times total-search <search-time>
where <search-time> is the time in minutes that the G700 searches for both primary controllers
or LSPs. The range is from 1 to 60.
3At the MG-001-1(configure)# prompt, type set mgp reset-times transition-point
<#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the primary
controller is an S8500 or S8700, the range is from 1 to 4. If the primary controller is an S8300,
<#_of_primary> must be 1.
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered : YES
Active Controller : 135.9.71.95
H248 Link Status : UP
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST DHCP SPECIFIED MGC HOST
-------------------- -----------------------
135.9.71.95 -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --