4Installing a New G700 without an S8300
Administer Communication Manager
206 Installation and Upgrades for G700 and S8300
December 2003
3Close the screen.
Administer the LSP Form
If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable the LSPs
to get translations updates from the primary controller. Once the LSPs are successfully entered on the
LSP form, their status can be viewed with the display lsp command.
NOTE:
The LSP node names must be administered on the node-names-ip form before they can be
entered on the LSP form.
Add LSP names to the LSP form
1At the SAT prompt, type change lsp to open the LSP form.
LSP Screen
2Enter the node name for each LSP supported by the primary controller and submit the form.
To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT session.
Enable Ethernet
Port? The Ethernet port must be enabled (y) before it can be used. The port
must be disabled (n) before changes can be made to its attributes on
this screen.
Network Region The region number for this IP interface.
VLAN The VLAN number assigned to the C-LAN, if any.
Number of CLAN
Sockets Before
Warni ng
The threshold for the number of sockets used by this C-LAN that
triggers a warning message to be sent to the error log.
Field Conditions/Comments
2 of 2
change lsp Page 1 of 16
LOCAL SURVIVABLE PROCESSOR
Number NAME IP Address Service Translations
State? Updated
1 node-10-LSP_ 192.168.1.50 in-service 14:21 5/4/2003
2 ____________ out-of-service
3 ____________ out-of-service
4 ____________ out-of-service
5 ____________ out-of-service
6 ____________ out-of-service
7 ____________ out-of-service
8 ____________ out-of-service
9 ____________ out-of-service
10 ____________ out-of-service
11 ____________ out-of-service
12 ____________ out-of-service
13 ____________ out-of-service
14 ____________ out-of-service
15 ____________ out-of-service
16 ____________ out-of-service