1Roadmap and Reference
Navigational Aid for CLI Commands
66 Installation and Upgrades for G700 and S8300
December 2003
Navigational Aid for CLI Commands
This section describes a few Command Line Interface commands that you will need to navigate between
the processors on the G700.
Log in to the P330 stack processor. Default mode is "Supervisor" with a P330-1(super)# command-line
prompt.
The command-line prompts in an MGP session use the media gateway’s name that is assigned when it is
configured.
You can telnet to another processor from a current telnet session.
Command Purpose Prompt
super change to supervisor mode P330-y(super)#
or <MG-xxx>-y(super)#
where xxx is the media gateway number
assigned on the "add media-gateway" form,
and y is the "module number" of the G700 in
the stack.
configure change to configuration
mode P330-1(configure)#
or <MG-001>-1(configure)#
session <module #> mgp
(from a stack processor session) open a CLI session on the
mgp processor <MG-001>-1(super)#
session <module #> stack
(from an MGP session) open a CLI session on the
stack processor P330-1(super)#
session icc
(from an MGP session) open a CLI session on the
S8300 processor craft@<host name>>
session <#> open a session on the stack
processor in module (i.e.
another G700)<#> in the
stack
P330-<#>(super)#
exit close the current session
(and revert to the previous
session)
<command> help displays help for
<command>