4
Installing a New G700 without an S8300
Configure the G700
Installation and Upgrades for G700 and S8300 185
December 2003
Assign the IP Address to the G700 Media Gateway Processor
If, after you have assigned an IP address to the G700 processor, you telnet directly to the G700
Media Gateway processor, you will need to login, and the login name and password will be
provided in the planning documentation.
1At the MG-???-n(super)# prompt, type configure to change to configuration mode.
2Type nvram init to recondition the processor. (This command ensures that any existing
configuration information is cleared so you can enter the IP address and IP route information).
The system prompts you to verify that you want to erase the configuration.
3Answer the prompt by typing y(es).
This procedure re initializes the G700 software back to factory defaults so new IP addresses can
be stored correctly in the software. It also clears all configuration and administration on the G700
Media Gateway.
The G700 Media Gateway re initializes.
4At the P330-1(configure)# prompt, type session mgp.
5At the MG-???-1(super)# prompt, type configure to change to configuration mode.
6Type set interface mgp <vlan> <ip_address> <netmask> to assign an IP address to the
G700 Media Gateway. <vlan> is the vlan to be established on the customer’s local network. This
is usually 1. The <ip_address> <netmask> is the assigned addresses for the G700 Media
Gateway.
CAUTION:
If this G700 contains an S8300 configured as an LSP, use the VLAN administered on the
primary controller.
7At the MG-???-n(configure)# prompt, type reset mgp.
A system prompt asks to confirm the reset.
8Select Yes at the dialog box that asks if you want to continue.
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
media modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the media modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
9Log in again at the Welcome to P330 menu.
10 At the P330-1(configure)# prompt, type session mgp.
11 At the MG-???-1(super)# prompt, type configure to reach the configuration level of the
command line interface.
12 Type show interface mgp to verify that the G700 Media Gateway has the correct IP address.
Assign the Default IP Route to the G700 Media Gateway
1At the MG-???-n(configure)# prompt, type
set ip route 0.0.0.0 0.0.0.0 <default_gateway>
to specify the gateway to handle addresses outside of the local subnet. <default_gateway> is the
IP address of the default network gateway. This address should be available in the planning
documentation.
2Type show ip route mgp to view the results.