Avaya P117F(R) Installation, Setting the DIP switches, DIP Switches in their Default Positions

Chapter 2

Installation

Setting the DIP switches

First, set the DIP switches. The position of the switches depends on the application. The drawing below shows the default positions of the DIP switches on the rear panel of the P110 switch.

Figure 1 The P117F(R) Stackable Switch Rear Panel Showing the

DIP Switches in their Default Positions

•LSV – Last SW Version: The on-board agent of the P117F(R) can use either the latest downloaded software or a “Basic” version. The Basic version is factory loaded.

Ensure the Use Switch is set to the OFF position.

Once you have set the DIP switch, you may proceed with the physical installation of the switch.

Table 1	DIP Switches on the P117F(R) Stackable Switch
Switch	Function	OFF	ON (Default)
LSV	Last SW Version	Use the “Basic”	Use the latest
		software	downloaded
		version. This is	agent software.
		known as	This is known
		Bank A	as Bank B
USE SWITCH	Not applicable, for future use only

P117F(R) Stackable Switch Installation Guide 5