Badger Basket N64944-001 THE BADGER-RADIX User Guide February Stopping a Transmitter, Page 61 of

THE BADGER®-RADIX®User Guide

February 2007

Stopping a Transmitter

To use the Programmer to Stop the transmitter’s meter reading broadcast, align the optical port and the LED and touch the Stop Radio button “T”. If the port and the LED are aligned, you’ll hear a beep and see these messages that indicate success:

•Stop

•Done

Here’s what you would see if you stopped transmitter # 72110115.

Changing the Odometer setting

The most common use of the SET ODOMETER function is to clear a Tamper condition reported by a Transmitter. Besides clearing the tamper, the SET ODOMETER function will also allow you to change the meter reading stored in the transmitter.

Changing the odometer setting is performed in two steps:

•Perform a READ function

•Enter the new odometer value and perform the SET ODOMETER function

The READ function is described above. Once the Badger ORION® transmitter has been successfully read, you can continue with the SET ODOMETER function.

To use the Programmer to clear the tamper (the transmitter’s meter reading matches the odometer value), press the PROGRAM “P” key once the READ function has completed. The Programmer will clear the tamper without changing the stored meter reading.

To use the Programmer to change the transmitter’s stored meter odometer value, enter the odometer value you want the transmitter to store into the odometer field as follows. First, use the delete key on the keyboard below the screen (upper left corner, first press the Badger-Radix key) to remove the current reading from the field. Next, enter the desired reading by pressing the number keys on the keyboard. Finally, align the optical port and the LED and touch the Set Odometer button “O”. If the port and the LED are aligned, you’ll hear two beeps and see these messages that indicate success:

Page 61 of 73