13. Configurator, Warp User Interface
13.1 About the Warp UIOverview
Image 13-1
1Activefield
2 Selectedactive node
3 Activenode
4 Interpolationnode
5 Interpolationnode intersection
6 Activenode intersection
Nodes
Each dot in the grid indicates a node. The small dots are not active nodes and cannot be moved. The
bigger dots are active nodes and can be moved during the warping setup.
Active dots can have different colors when moving this dots.
• Green : node is not moved or is moved over less than 10%of its possible moving range. Noproblems
for the warping board.
• Yellow(orange ye llow) : node is moved over 10 to 20%. An warning can occ uro nt he warping board
butitisnotsure.
• Red : node is moved over more than 20. Error status for the warping board.
Active area
Yellow area around the selected node. When moving the active node, only the adjac ent nodes in the
yellow area will move accordingly.
Node selection
Single node or multi node selection is possible.
Toselect a single node , click on a big dot (active node) in the grid.
For a multiple selection,press the Ctrl key and double c lick on the nodes which must be joined as one
node. The selecte d nodes get an orange symbol on it to indicate that these nodes are joined together.
This selection will acts as a single node. Allacti ve nodes will move in the same direction.
Special cases of multi node selection are : afull row sel ection or a full column selection.
188 R5976924 PROJECTOR TOOLSET 16/04/2009