4. Getting Started
Image
RCU function indication
1 | Function keys | user programmable keys with functions for direct access. |
|
|
|
2 | ADJ. | Adjust key, to enter the adjustment mode |
|
|
|
3 | Address key | (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed |
|
| address key with a pencil, followed by pressing one digit button between 0 and 9. |
|
|
|
4 | Selection key (*) | to direct access the zoom/focus/shift functions. |
|
|
|
5 | PAUSE | to stop projection for a short time, press ’PAUSE’. The image disappears but full power is |
|
| retained for immediate restarting. |
|
|
|
6 | STBY | standby button, to start projector when the power switch is switched on and to switch off the |
|
| projector without switching off the power switch. |
|
| Attention : Switching to Standby. When the projector is running and you want to |
|
| go to standby, press the standby key for 2 seconds until the message ’Saving data, |
|
| please wait’ is displayed. Do not press any longer on the standby key otherwise |
|
| the projector will restart. |
|
|
|
7 | MUTE | to interrupt the sound reproduction. |
|
|
|
8 | ? | Auto image, to center the image on the active LCD surface. |
|
|
|
9 | Digit buttons | direct input selection. |
|
|
|
10 | Audio controls | use these buttons to obtain the desired sound level. |
|
|
|
11 | Picture controls | press to adjust the projected image. |
|
|
|
12 | Phase | press to adjust the phase of the projected image. |
|
|
|
13 | FREEZ | press to freeze the projected image. |
|
|
|
28 |
| R5976182 BARCOREALITY 6500 30012001 |
