Barco R9001960 8.10 800 peripheral, Set up the network configuration, Which module are available?

8. Installation mode

Set up the network configuration

To set up the network configuration, follow the next procedure

1.Push the cursor key ↑ or ↓ to highlight Network Configuration. (menu 8-22)

2.Press ENTER to display the network configuration menu. (menu 8-23)

3.Set DHCP on or off (contact your network responsible for the correct setting in your environement).

DHCP on	DHCP server assigned an IP address to the client (network projector).
DHCP off	the client has to fill out the IP address, the subnet mask and the default gateway.

INSTALLATION

INPUT SLOTS

NO SIGNAL

LENS

TEXT BOX POSITION

QUICK ACCESS KEYS

START UP MODE

NETWORK CONFIGURATION

more ...

Select with ↑ or ↓ then <ENTER> <EXIT> to return.

Menu 8-22

Network configuration

DHCP: ON

IP ADDRESS: 159.150.160.200 SUBNET MASK: 158.150.160.201

DEFAULT GATEWAY: 158.150.300.300

APPLY

Select with ↑ or ↓ <ENTER> to edit Reprogram with ↑ or ↓ or numeric keys Apply to confirm <EXIT> to return.

Menu 8-23

Entering the necessary addresses

1.Select the IP address with the cursor keys. (menu 8-24)

2.Enter or reprogramm the address with the numeric keys (contact your network responsible for the correct address). Note: An address contains 4 octets with a maximum value of 255, separated by a bullet.

3.Repeat the above steps for the subnet mask and the gateway.

4.Select APPLY and press ENTER to install the entered addresses.

If a wrong value for an octet is entered, the following error message will be displayed to indicate where the error is located. Example of message : "Invalid octet in field Subnet mask, Maximum value is 255 for each octet ! " (menu 8-25)

Network configuration

DHCP: ON

IP ADDRESS: 159.150.160.200

SUBNET MASK: 158.150.160.201

DEFAULT GATEWAY: 158.150.300.300

APPLY

Select with ↑ or ↓ <ENTER> to edit Reprogram with ↑ or ↓ or numeric keys Apply to confirm <EXIT> to return.

Menu 8-24

NETWORK CONFIGURATION

INVALID OCTED IN

FIELD

SUBNET MASK

MAXIMUM VALUE IS

255 FOR EACH OCTET !

<ENTER> to continue

Menu 8-25

8.10 800 peripheral

The following thinks can be installed for a 800 peripheral:

•Defining the Output module of the RCVDS05

•Defining the Infrared Communication protocol

8.10.1 Defining the Output module of the RCVDS05

Which module are available?

When a RCVDS05 is connected to the projector, the type of output module of this RCVDS05 has to be defined in the 800 peripheral menu.

•standard output module

•5 cable output module

72 R5976182 BARCOREALITY 6500 30012001