9. Service mode
9. SERVICE MODE
9.1 Build-up
Build-up
The service menu is
9.2 Start up
Start up
1.Push the cursor key ↑ or ↓ to highlight Service. (menu
2.Press ENTER to display the service mode menu. (menu
ADJUSTMENT MODE
Select a path from below :
AUTO IMAGE
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with ↑ or ↓ then <ENTER> <EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC RESET LAMP RUNTIME LAMP RUNTIME HISTORY LAMP DIMMING MORE...
Select with ↑ or ↓ then <ENTER> <EXIT> to return.
SERVICE
BARCO LOGO
PANEL ADJUSTMENTS
UNIFORMITY
RESET INPUT BALANCE
I2C DIAGNOSIS
Select with ↑ or ↓ then <ENTER> <EXIT> to return.
Menu | Menu | Menu |
Some items in the Service mode are password protected (when the password function is active). Enter the password to continue. All other password protected items are now available if you stay in the adjustment mode.
9.3 Identification
What can be seen on the identification screen?
The identification screen shows the general information of the projector.
The following items will be displayed:
•Type of projector: BARCOREALITY SIM6
•Software version
•Network module: yes
•Proj. address: To change the address of the projector, see Box content, page 5
•Installation:
-front/ceiling
-front/table
-rear/ceiling
-rear/table
•Baud rate: transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be the same as the baud rate of the connected computer. When there is a difference, consult ’Change Baudrate PC’ in this chapter.
•Projector Run Time: gives the total run time since the first start up. All projectors leave the factory with a run time of approxi- mately 24 hours.
•Projector Serial number: indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.
R5976182 BARCOREALITY 6500 30012001 |
| 77 |
|
