6. Advanced
What can be done ?
The aim here is toalways show the resolution of the source independently of the resolution of the LCD panels. This way better
imagereproduction is obtained since no up or do wn scaling isdone o n the source.
Note that nativeresolution refers here to the source and does thus only have sense when handling data sources (greyed out for
video sources).
Dependingon the type of projector the “show native resolution” function will handle the sources as follows:
Source Projectedimage
Name Ratio Resolution Ratio Resolution Display
xga 4:3 1024x768 4:3 1024x768 imagecentered +side blanked
sxga 5:4 1280x1024 5:4 1280x1024 image centered +side blanked
sxga+ 4:3 1400x1050 4:3 1400x1050 image centered
uxga 4:3 1600x1200 4:3 1600x1200 scroll image
Table 6 -1
Shownative resolution = ON
TheFull screen represen tationfunction on the other hand forces to use the complete native resolutionof the
LCD panels.
How to enable the “Show native resolution” function?1. Press MENU to activate the Tool bar
2. Press →to select the Image item
3. Press ↓to Pull down the Image menu
4. Use ↑or ↓to select Show native resolution
Image6-28
5. Press →to pull down the menu
6. Use ↓or ↑to select On
7. Press ENTER
A white bullet shows the selection
Thedefault mode is used if the Show native resolution and the Full screen representation are off.
The default mode shows always the native ratio and forces the native resolution of the panels (part of the
image blanked where needed)
56 R59770134 ID LR-6 27/05/2011