4. Setup
Image4-2
1 Functionke ys userprogrammable ke yswith fu nctionsfor direct access.
2 MENU Menu key,to enter or exit the Toolbar menu.
3 Address key (recessedkey), to enter the address of the projector (between 0 and 9). Press the recessed
addresskey with a pencil, followed by pressing one digit button between 0 and 9.
4LOGO key allowsto recall the stored Logo (not in PiP mode)
5PAUSE tostop projection for a short time, press ’PAUSE’. The image disappears but full power is
retainedfor immed iaterestarting.
6STBY standbybutton, to start projector when the power switch is switched on and to switch off the
projectorwithout switching off the po wer switch.
Attention: Switchingto Standby. When the projector is running and you want togo
tostandby, press the standby key for 2 seconds.
7MUTE tointerrupt the sound reproduction (audio = optional.
8AUTOIMAGE Autoimage, to center the image on the active LCD surface.
9 Digitbu ttons directinput selection.
9b SOURCE button thisbutton allows to switch through the active (scanned) inputs
10 Lens control usethese buttons to obtain the desired ZOOM, SHIFT, FOCUS.
11 VOL usethis button to obtain the desired sound level (audio = optional)
12 Picturecontrols usethese buttons to obtain the desired picture analog level.
13 DIGIZOOM allowsa digital Zoom of a part of the image
14 FREEZ press to freeze the projected image.
15 PIP allowsto activate the PICTURE IN PICTURE mode
R59770134 ID LR-6 27/05/2011 27