6. Advanced
9. Adjust the blue white level (gain) on a minimal value
Note: thisminimal value is not necessary , provided that the 2 other colors are not influencing too much the color to be adjusted,
in fact the aim is to minimize the effect of the two other colors since there is a risk of reaching too soon the transition
(brightspots) due to the contribution of these two other colors signals.
10.Adjust theG reen whitelevel (gain) until bright spots appear on the white part of the image
11.Adjust the Blue whitelevel (gain) until bright spots appear on the white part of the image
12.Adjust the Red white level(gain) until bright spots appear on the white part of the image
The projected image should now be noisy neutral grey.
ifone uses a gray scale pattern, the bright spots shouldappear in the white bar.
SelectingPreset restores the factory input balance setting
Theinput balance settings are stored in the image file, each source has its own input balance.
6.4.11 AGC on Video
AGC
AutomaticGain Control: allowsan automatic amplitude (gain) control of the incoming video signal
AGC isonly for Video signals
Enabling/disabling the AGC
1. Press MENU to activate the Tool bar
2. Press →to select the Image item
3. Press ↓to Pull down the Image menu
4. Use ↑or ↓to selec t AGC on Video
5. Press →to pull down the menu
6. Use ↓or ↑to enable or disable the AGC
7. Press ENTER
A white bullet shows the activese tting
R59770134 ID LR-6 27/05/2011 73