![](/images/new-backgrounds/1186590/18659051x1.webp)
4.If the projector is activated for the first time, select your OSD language following the on- screen instructions.
5.If you are prompted for a password, press the arrow keys to enter a six digit password. See "Utilizing the password function" on page 30 for details.
6.Switch all of the connected equipment on.
7.The projector will start to search for input signals. The current input signal being scanned displays in the screen. If the projector doesn't detect a valid signal, the message 'No Signal' will continue displaying until an input signal is found.
You can also press Source on the projector or remote control to select your desired input signal. See "Switching input signal" on page 32 for details.
• If no signal is detected for 3 minutes, the projector automatically enters ECO BLANK mode.
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1
1. | Press the |
|
| |
| of the projector. Once the image is positioned |
|
| |
| where you want it, release the |
|
| |
| button to lock the foot in position. |
|
| |
2. | Screw the rear adjuster foot to fine tune the |
|
| |
| horizontal angle. | 2 | 1 | |
To retract the foot, hold up the projector while | ||||
|
pressing the
If the projector is not placed on a flat surface or the screen and the projector are not perpendicular to each other, the projected image becomes trapezoidal. To correct this situation, see "Magnifying and searching for details" on page 33 for details.
•Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
•Be careful when you press the adjuster button as it is close to the exhaust vent where hot air comes from.
26 Operation