5. Operation
Starting up the projector
1.Plug the power cord into the projector and into a wall socket. Turn on the wall socket switch (where fitted).
2.Press the main power switch to the I position.
Check that the Power indicator on the projector lights orange after power has been applied.
3.Remove the lens cap.
If it is left on, it could become deformed due to the heat produced by the projection lamp.
4. | Press and hold (for 2 seconds) II on the projector or |
| remote control to start the projector. |
| The Power indicator light flashes green and stays green |
when the projector is on.
The start up procedure takes about 30 seconds after
pressing II . In the later stage of start up, a default BenQ logo is projected.
(If necessary) Rotate the focus ring to adjust the picture clearness.
5.If you are prompted for a password, press the arrow keys to enter a six digit password.
6.Switch all of the connected equipment on.
The projector will start to search for input sources. The current input source being scanned displays in the lower right corner of the screen. If the projector doesn't detect a valid signal, the searching message will continue displaying until an input source signal is found.
You can also press SOURCE on the projector or remote control to display the signal selection bar and switch between different signals. See "Switching input source" on page 35 for details.
If the projector is still hot from previous activity, it will run the cooling fans for approximately 90 seconds before energizing the lamp.
See "Utilizing the password function" on page 32 for details.
If the frequency/resolution of the input source exceeds the projector's operating range, you will see the message 'Out of Range' displayed on a blank screen. Please change to an input source which is compatible with the projector's resolution or set the input source to a lower setting. See "Timing chart" on page 77 for details.
30 Operation