If you forget the password
If the password function is activated, you will be asked to enter the
If you enter an incorrect password 5 times in succession, the projector will automatically shut down in a short time.
Password Error
Please try again.
Entering the password recall procedure
1.Press and hold AUTO on the projector or remote control for 3 seconds. The projector will display a coded number on the screen.
2.Write down the number and turn off your projector.
3.Seek help from the local BenQ service center to decode the number. You may be required to provide proof of purchase documentation to verify that you are an authorized user of the projector.
Recall Password
Please write down the recall code, and contact your local BenQ Customer Center.
Recall code: | 0 2 1 2 |
Back EXIT
Changing the password
1.Press MENU on the projector or remote control and then press / until the Advanced Setup menu is highlighted.
2.Press / to highlight Password and press ENTER. The Password page displays.
3.Highlight Change Password and press ENTER. The Input Current Password page displays.
4.Enter the old password.
•If the password is correct, the message 'Input New Password' displays.
•If the password is incorrect, the password error message displays lasting for three seconds, and the message 'Input Current Password' displays for your retry. You can either press MENU to cancel the change or try another password.
5.Enter a new password.
IMPORTANT: The digits being input will display as asterisks
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6.Confirm the new password by
Operation 33