Adjusting the sound

The sound adjustments made as below will have an effect on the projector speaker and, if using external speakers, on the audio output signal.

Be sure you have made a correct connection to the projector audio input(s) and, if using external speakers, to the projector audio outputs. See "Connecting Audio device" on page 29 for details.

Muting the sound

Press MUTE on the remote control to temporarily turn off the sound. While the sound is off, the screen will display in the upper right corner of the screen.

To restore the sound, press MUTE again.

You can also toggle the audio between on and off in the Advanced Setup > Audio menu. See the OSD picture on this page for details.

Other sound adjustments

1.Press AUDIO on the remote control to display the Audio page.

(The secondary option to access the Audio menu is to press MENU to open the OSD menu, highlight Audio in the Advanced Setup menu, and press ENTER.)

2.To adjust the sound volume, press to

highlight Volume and press / to adjust the level.

3.To adjust the sound treble, press to

highlight Treble and press / to adjust the level.

4.To adjust the sound bass, press to

highlight Bass and press / to adjust the level.

Advanced Setup

Lamp

 

Audio

 

ENTER

 

 

 

Pattern

 

 

 

 

 

 

High Altitude Mode

 

Off

 

 

 

Password

 

 

 

 

 

 

Key Lock

 

 

 

 

 

 

Reset All Settings

 

 

 

 

 

 

Analog RGB

 

EXIT

Back

 

Audio

 

 

 

 

 

 

Mute

 

Off

 

 

 

Volume

+5

 

 

 

 

 

Treble

+5

 

 

 

 

 

Bass

+5

 

 

 

 

 

 

 

EXIT

Back

 

 

 

 

Selection

Pressing

 

 

 

 

 

 

Volume

smaller

 

louder

 

Treble

weaker

 

stronger

 

Bass

weaker

 

stronger

 

 

 

 

 

 

 

Operation 55