Operation
Starting up the projector
1.Plug the power cord into the projector and into a wall socket. Turn on the wall socket switch (where fitted).
English
For safety reasons, use a 15A extension cord if needed.
2. Press II Power on the projector or remote control to start the projector. As soon as the lamp lights up, a "Power On Tone" will be heard. The POWER indicator light flashes green and stays green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
To turn of the ring tone, see "Turning off the Power on/off ring tone" on page 38 for details.
3.If you are prompted for a password, press the arrow keys to enter a six digit password. See "Utilizing the password function" on page 25 for details.
4.Switch all of the connected equipment on.
5.The projector will start to search for input signals. The current input signal being scanned displays in the upper left corner of the screen. If the projector doesn't detect a valid signal, the 'No Signal' message will continue displaying until an input signal is found.
You can also press SOURCE on the projector or remote control to select your desired input signal. See "Switching input signal" on page 27 for details.
If the projector is still hot from previous activity, it will run the cooling fans for approximately 90 seconds before energizing the lamp.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message 'Out of Range' displayed on a blank screen. Please change to an input signal which is compatible with the projector's resolution or set the input signal to a lower setting. See "Timing chart" on page 53 for details.
To maintain the lamp life, once you turn the projector on, wait at least 5 minutes before turing if off.
Operation 23
