7.Lift the handle so that it stands up. Use the handle 12. Replace the lamp cover on the projector. to slowly pull the lamp out of the projector.
1
2
| 13. | Tighten the screw that secures the lamp cover. |
Pulling it too quickly may cause the lamp to |
|
|
break and scatter broken glass in the |
|
|
projector. |
|
|
Do not place the lamp in locations where |
|
|
water might splash on it, children can reach |
|
|
it, or near flammable materials. |
|
|
Do not insert your hands into the projector |
|
|
after the lamp is removed. If you touch the |
|
|
optical components inside, it could cause |
|
|
color unevenness and distortion of the |
| Loose screw may cause a bad connection, |
projected pictures. |
| |
8. As shown in the figure, hold the new lamp and |
| which could result in malfunction. |
| Do not over tighten the screw. | |
align the two locators on the lamp with the holes |
| |
|
| |
on the projector, and then insert the lamp all the | 14. | Restart the projector. |
way into the projector. |
| Do not turn the power on with the lamp cover |
|
|
removed.
English
9.Tighten the screw that secures the lamp.
10.Connect the lamp connector to the projector and tighten the screw that secures the lamp connector.
Resetting the corresponding lamp timer
15.After the startup logo, open the
Go to the SYSTEM SETUP: Advanced > Lamp Settings menu.
Press ENTER and the Lamp Settings page displays.
Highlight Reset Lamp #1 Timer/Reset Lamp #2 Timer. A warning message displays asking if you want to reset the lamp timer.
Highlight Reset and press ENTER on the projector or remote control. The lamp time will be reset to '0'.
Notice
Reset Lamp #1 Timer
Reset Cancel
Loose screw may cause a bad connection,
which could result in malfunction.Do not reset if the lamp is not new or replaced as this could cause damage.
Do not over tighten the screw.
11.Ensure the handle is fully laid flat and locked in place.
Maintenance 49
