Black Box 3600 MODEM manual Entering Remote Configuration %T=, &T

AT Commands

Command	Operation
%P=	Sets security code to a value 0 to 99999999
	entered after the equal sign
%P?	Requests local security code to be displayed
%P=D	Access for remote configuration is not possible
	when security code is disabled
%P=(blank)	Clears security code

The %P=D command disables remote configuration. To enable remote configuration, insert another security code.

IMPORTANT: Do not forget your remote security code. Keep your code in a safe place. If you do forget your code, contact Technical Support. Refer to the “Calling Technical Support” section on page 12-2.

Entering Remote Configuration %T=, &T

This mode of operation allows you to view or modify the option set of a compatible remote modem. Enter the %T= (security code of remote) command to initiate remote configuration.

The modem is shipped from the factory with security code (blank). This allows remote configuration by using (blank) as the security code.

Command	Operation
%T=	This command followed by the correct security
	code establishes remote configuration
&T	Exits remote configuration

Remote Configuration can also be specified by the dial command by placing %T (password) after the dial digits (the equal sign is left off). For example,

ATD 555-1212%T01234

Enabling/Disabling Remote Configuration *RA

The *RA commands enable and disable remote configuration.

Command	Operation
*RA	Disable remote configuration
*RA1	Enable remote configuration

Modem 3600 5-43