If you wish to continue listening to the first programme, switch REGIONAL ON by
•pressing AF/# for approximately 1 sec- ond until “REGIONAL ON” appears in the first line.
When the regional function has been switched on “REG” will replace “AF” in the display.
If you leave the service area of the regional programme you are currently tuned into, or if you would like to take advantage of the full RDS service, switch to “REGIONAL OFF”.
•Press AF/# for approximately 1 second until “REGIONAL OFF” appears.
Selecting a waveband
You can select between the following wave- bands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz
LW 153 - 279 kHz
•Use BND to select the waveband. Press repeatedly if necessary.
Station tuning
Seek tuning 
/
•Press 
/
; the car radio will automati- cally search for the next station.
If you hold down 
/
(also applies to re- mote control operation), seek tuning will speed up in upwards or downwards direc- tion.
Seek tuning
Up
Down
<</ >> Up/Down in increments (for FM only when AF is switched off)
Manual tuning with << / >>
You can also tune in a station manually.
Important:
AF must be switched off (i.e. the “AF” or “REG” symbol does not light up in the dis- play).
If necessary, deactivate this function:
•Press AF/#.
Manual tuning:
•Press << / >>; the frequency will change in degrees in the downwards or upwards direction.
If you hold down the right or left part of the rocker switch, the frequency scan will speed up in the corresponding direction.
Entering the frequency directly
For FM or FMT, it is possible to enter the station frequency directly.
Start your entry
•by pressing 0.
•Then enter the frequency, beginning with the first digit. You need not enter a decimal point.
Press CL to cancel this process or OK to confirm your selection.
80
