Blodgett XR8-G manual Troubleshooting Guide, Maintenance, Possible Causes, Suggested Remedy

Models: XR8-G

1 39
Download 39 pages 3.65 Kb
Page 21
Image 21
Troubleshooting Guide

 

 

 

 

Maintenance

 

 

 

 

 

 

 

 

 

 

 

Troubleshooting Guide

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

POSSIBLE CAUSE(S)

 

SUGGESTED REMEDY

 

 

 

 

 

 

 

 

 

 

 

SYMPTOM: Oven will not fire.

 

 

 

 

 

 

 

 

 

 

 

S

Gas turned off.

S

Turn the gas valve to ON.

 

 

 

S

Oven not plugged in.

S

Plug in electrical supply cord.

 

 

S

Power switch on the control panel is off.

S

Set the control panel to ON.

 

 

S

Control set below ambient temperature.

S

Set to desired cook temperature.

 

 

S

Doors are open.

S

Close doors.

 

 

S

No draft on the burner.

S

Check draft inducer opening.

 

 

 

 

 

 

 

 

 

 

SYMPTOM: Oven does not come to ready.

 

 

 

 

 

 

 

 

 

 

S The oven has not reached preheat temperature.

S

Wait for oven to reach preheat temperature.

 

 

 

S

Gas valve not turned on completely.

S

Check the gas valve, turn on fully if necessary.

 

 

S

The quick disconnect is not connected.

S Reconnect the quick connect. Check all gas

 

 

 

 

 

connections.

 

 

S

Gas pressure to oven is too low.

S

Call your local gas representative.

 

 

S Internal problem with main temperature control.

S

*

 

 

 

 

 

 

 

 

 

 

 

SYMPTOM: Convection fan does not run.

 

 

 

 

 

 

 

 

 

 

 

S

Oven is not plugged in.

S

Plug in electrical supply cord.

 

 

 

S

Circuit breaker tripped.

S

Reset the breaker.

 

 

S

Doors are open

S

Close doors.

 

 

S

Blower delay was set.

S

Reset blower delay time.

 

 

 

 

 

 

 

 

 

 

SYMPTOM: General baking problems.

 

 

 

 

 

 

 

 

 

 

 

 

S

Thermostat out of calibration.

S

*

 

 

 

S

Improper oven venting.

S

*

 

 

 

 

 

 

 

 

 

SYMPTOM: Rack does not stop rotating after doors are opened or rack stops in wrong position.

 

 

 

 

 

 

 

 

 

S

Rack rotator switch out of position

S

Reposition rack rotator switch

 

 

 

 

 

 

 

*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that

 

 

 

All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator. Blodgett cannot as-

 

 

sume responsibility for damage as a result of servicing done by unqualified personnel.

 

 

 

 

 

 

 

 

WARNING!!

Always disconnect the power supply before cleaning or servicing the oven.

17

Page 21
Image 21
Blodgett XR8-G manual Troubleshooting Guide, Maintenance, Possible Causes, Suggested Remedy