Bosch Appliances D7212G Telephone Connections 6.0Telephone Connections, 6.1Registration, Location

D7212G

Telephone Connections

6.0Telephone Connections

6.1Registration

The Bosch Security Systems D7212G Control/Communicator is registered with the Federal Communication Commission under Part 68, for connection to the public telephone system using an RJ31X or RJ38X jack installed by the local phone company.

Note: An RJ31X jack can be modified by placing a jumper wire between Terminals 2 and 7 to become an RJ38X jack.

6.2Notification

Do not connect registered equipment to party lines or coin-operated telephones. The local telephone company must be notified and supplied with the following information before connecting the panel to the telephone network:

•The particular line to which the panel will be connected

•Make (Bosch Security Systems), model (D7212G), and serial number of the panel

•FCC registration number and ringer equivalence for the panel:

- FCC Registration Number: AJ9MUL-46532-AL-E				RJ31X	RJ31X
	RING (red)				Jack
			TIP (green)
- Ringer Equivalence: 0.1B	R1	R	T T1

6.3	Location		1	2	4	5	7 8
To prevent jamming of signals, wire the RJ31X or RJ38X jack
before the in-house phone system to support line seizure. See			1		4	5	8
							TELCO
Figure 8. Install the jack on the street side of the phone switch,		(TIP)	(RING)				Connector
							Block
wired ahead of any PBX equipment. Line seizure provides for a			1		4	5	8
temporary interruption of normal phone usage while the
communicator transmits data. After installation, confirm that
the panel seizes the line, acquires dial tone, reports correctly to			Outside
the receiver, and releases the phone line to the in-house phone			TELCO
system.					Premises
					Telephone
6.4	Phone Cord Connection		Figure 8: RJ31X Wiring

Connect one end of a D161 (7 ft. [2.1 m]) or D162 (2 ft. [61 cm]) Telephone Cord to the TELCO Cord connector located on the bottom left corner of the panel. See Figure 9. Connect the other end to the RJ31X or RJ38X jack.

Note:

To supervise the phone cord, use an RJ38X jack.

Telephone Cord

E

D

I

Connector

N

S

A

A

GROUND START

RED PHONE

B

B

Requires

LED

11

12

13

14

15

16

17

18

19

20

21

22

L

Relay Model

ON WHEN

L

GRN

D136 in Ground

COMMUNICATING

E

E

Start Socket

OFF WHEN IDLE

Phone LED

Operation Monitor

(Red)

LED (Green)

Figure 9: Phone Connector and LED and Operation Monitor LED Locations

6.5Phone LED (Red)

The red Phone LED lights when the panel seizes the phone line and remains lit until the panel returns the phone line. See Figure 9 for the location of the red LED.

D7212G Operation and Installation Guide

© 2003 Bosch Security Systems Page 31 4998138544C