DinionHD 720p IP Camera | Maintenance en 121 |
|
|
12 Maintenance
12.1Testing the network connection
The ping command can be used to check the connection between two IP addresses. This allows testing whether a device is active in the network.
1.Open the DOS command prompt.
2.Type ping followed by the IP address of the device.
If the device is found, the response appears as " Reply from ... ", followed by the number of bytes sent and the transmission time in milliseconds. Otherwise, the device cannot be accessed via the network. This might be because:
–The device is not properly connected to the network. Check the cable connections in this case.
–The device is not correctly integrated into the network. Check the IP address, subnet mask, and gateway address.
12.2Repairs
CAUTION!
Never open the casing of the unit. The unit does not contain any user serviceable parts. Ensure that all maintenance or repair work is performed only by qualified personnel (electrical engineering or network technology specialists). In case of doubt, contact your dealer's technical service center.
12.2.1Transfer and disposal
The camera should only be passed on together with this installation guide. The unit contains environmentally hazardous materials that must be disposed of according to law. Defective or superfluous devices and parts should be disposed of professionally or taken to your local collection point for hazardous materials.
Bosch Security Systems | Installation and Operation Manual |
