E n g l i s h
PLUMBING PREPARATION
B
14"
(355mm)
A
Figure 7/Ilus. 7
WARNING: SCALD HAZARD - Serious injury could result if work is performed on a charged hot water line. Only qualified plumbers should perform plumbing work. Do not attempt any work on the dishwasher hot water supply plumbing until you are certain the hot water supply is shut off.
CAUTION: Temperatures required for soldering and sweating will damage the dishwasher’s base and water inlet valve. If plumbing lines are to be soldered or sweated, keep the heat source at least 6 inches (152.4 mm) away from the dishwasher’s base and water inlet valve.
Hot Water Supply
Bosh recommends that the hot water heater be set to deliver approximately 120° F (49° C) water to the dish- washer. Water that is too hot can cause some detergents to loose effectiveness. Lower water tempera- tures will increase run times.
The hot water supply pressure must be between 5 - 120 psi (0.3 - 8.27 bars).
Hot Water Supply Plumbing
NOTE: Regardless of where the hot water supply line enters the enclosure (following the guidelines on page 8), position the line 14” (355mm) from the enclosure’s left side, as shown in Figure 7, letter A.
NOTE: Decide whether braided hose or copper tubing will be used for the hot water supply plumbing, and purchase the correct type of hot water supply
Install an easily accessible
All solder connections must be made before the water line is connected to the dishwasher’s water inlet valve. Water may also be supplied to the dishwasher by using a braided hose line. Check with your local plumbing supply sources for the proper hose and 90° elbow fitting.
(Continued on next page)
