CA
B |
D
Figure 31/Ilus. 31
E n g l i s h
BASE AND TOE PANEL (Continued)
SHY66 & SHX56 Models Base and Toe Panel Installation
1)Place the Base Part under and up the front bottom panel of the dishwasher, as shown in Figure 31.
2)Insert the Base Part screws (Figure 1, letter O) into the Base Part, as shown in Figure 31, letter B. Tighten the Base Part Screws.
3)Place the Cotton Insulation Strip (Figure 1, letter C) under the unit, between the bottom of the Base Part and the floor, as shown in Figure 31, letter C.
4)Place the toe panel over the Cotton Insulation Strip, and use the toe panel screws (Figure 1, letter N) to secure the toe panel in place, as shown in Figure 31, letter D.
FINAL INSTRUCTIONS
1)Energize the dishwasher power supply circuit.
2)Consult the Bosch Dishwasher Use and Care Manual, and run the dishwasher through one complete cycle.
If the dishwasher does not operate properly, refer to the
CUSTOMER SERVICE
Your Bosch dishwasher requires no special care other than that described in the Care and Cleaning section of the Use and Care Manual. If you are having a problem with your dishwasher, before calling for service please refer to the
If you are having a problem with your Bosch dishwasher and are not pleased with the service
you have received, please take the following steps (in the order listed below) until the problem
is corrected to your satisfaction.
1.Contact your installer or the Bosch Authorized Service Contractor in your area.
2.
3.Write us at the address below:
BSH Home Appliances, Corp. 5551 McFadden Avenue Huntington Beach, CA 92649