Bosch Appliances SHV99A SHX33A, SHU53E, SHU66E, SHY99A Electrical Connection, Base and TOE Panel

1/8”

3mm

Figure 28/Ilus. 28

Figure 29/Ilus. 29

Figure 30/Ilus. 30

E n g l i s h

ELECTRICAL CONNECTION (continued)

WARNING: FIRE HAZARD - LOOSE OR IMPROPER ELECTRICAL CONNEC- TIONS CAN CAUSE FIRE. MAKE CER- TAIN THAT ALL ELECTRICAL CONNEC- TIONS ARE PROPERLY MADE.

•Do not pre-twist the wires before connecting them with wire nuts.

•Extend the dishwasher’s stranded wires 1/8” (3mm) beyond the power supply cable’s solid wires, as shown in Figure 28.

5) Using the supplied wire nuts, connect the electrical supply wires to the dishwasher’s wires, black to black, white to white, and green or bare to green or bare. Make certain that the insulated wires show no bare wire from the bottoms of the wire nuts. Gently tug the wires to make certain they are securely connected.

6) Press the wires into the junction box. Make certain that the wire nuts do not loosen.

7) Place the cover on the juction box and secure it to the junction box with the supplied screw.

DOOR TENSION ADJUSTMENT (only on SHI and SHV models)

After the dishwasher is installed, open and close the door several times to make sure that it does so with ease. If the door closes too quickly or if the door falls open, the spring tension needs to be adjusted.

To Adjust the Spring Tension:

1)Obtain the provided Door Tension Screws (Figure 1, letter K) from the SHI/ SHV parts bag.

2)Insert the screws as shown in Figure 29. Turning the screw clockwise increases the spring tension. Turning the screws counter-clockwise decreases the spring tension.

BASE AND TOE PANEL

Regular Toe Panel Installation

Use the toe panel screws (Figure 1, letter D) from the Dishwasher Installa- tion Kit and a Torx screwdriver to install the toe panel as shown in Figure 30.

(Continued on next page)

28 Base and Toe Panel Base et Panneau inférieur Base y Panel de Pie