Brady 2034, 2024 manual 2 Communications Dip Switch Settings

2.3.2Dip Switch Settings

For proper operation, you must set the baud rate, parity, and stop bits of the Printer's interface. On the rear of the Printer, you will find SWITCH 1 (S1), an eight-position dip switch used to set the Printer's communications parameters, (see Table 2-3).

NOTE: SWITCH 1 (S1) is not available with the LCD/Keypad Front Panel Option, (see Section 3.2 when setting the communications parameters for this option).

	S1-1	S1-2	S1-3	S1-4	S1-5	S1-6	S1-7	S1-8
Baud Rate
9600	OFF	OFF	OFF	X	X	X	X	X
4800	OFF	OFF	ON	X	X	X	X	X
2400	OFF	ON	OFF	X	X	X	X	X
1200	OFF	ON	ON	X	X	X	X	X
600	ON	OFF	OFF	X	X	X	X	X
300	ON	OFF	ON	X	X	X	X	X
19200	ON	ON	OFF	X	X	X	X	X
TEST/9600	ON	ON	ON	X	X	X	X	X
Word length/Parity
7-Bit /Even	X	X	X	ON	X	X	X	X
8-Bit /None	X	X	X	OFF	X	X	X	X
Compatibility Mode
(Form Edge Offset)
Offset =1.10" (27.9mm)	X	X	X	X	OFF	X	X	X
Offset =2.20" (55.9mm)	X	X	X	X	ON	X	X	X
Present Sensor
Enable	X	X	X	X	X	ON	X	X
Disable	X	X	X	X	X	OFF	X	X
Control Codes
Standard	X	X	X	X	X	X	OFF	X
Alternate	X	X	X	X	X	X	ON	X
Cutter Enable
Disable	X	X	X	X	X	X	X	OFF
Enable	X	X	X	X	X	X	X	ON

Table 2-2 Communications Dip Switch Settings

NOTE: Select the 8-bit word length if you wish to access the foreign language characters from the ASCII Code chart. These characters are available in fonts 1–6 and 9.

_______________________________________________________________________

Getting Started 13