Brocade Communications Systems SBCEBFCSW manual Installing a switch module

Switch module

SBCE unit

O
K!
2G TX
RX	!
	0
	F
	C
	15
2
G TX	!
RX

Release lever

Release-lever latch

	O
	K!
		LI
		NK
		1
		T
		X/R	X
		LI
		NK
		2
		T
		X/R	X
		LI
		NK
		3
		T
		X/R	X
		LI
		NK
		4
	00	TX/
	055	RX
	D89
		A1
		44
O
K!
	O
	K!
2G TX
RX	!
		LI
		NK
	0	1
		T
		X/R	X
		LI
	F	NK
		2
	C
		T
	15	X/R	X
		LI
		NK
2		3
G TX		TX/
RX	!	RX
		LI
		NK
		4
	00	TX/
	055	RX
	D89
		A1
		44

AC DC

AC DC

Figure 6. Installing a switch module.

11.Raise the release lever until it moves to the upright (closed) position. This locks the switch module in the SBCE unit.

✏NOTE

The switch module takes approximately 60 seconds to complete the power-on self-test (POST). When the switch module is turned on, an LED test occurs. All LEDs are lit and remain lit for approximately 5 seconds; then, the LEDs will all turn off, except the OK LED. The OK LED flashes to indicate a normal POST condition; then, POST proceeds as described in the next step.

✏NOTE

To maintain proper airflow, make sure that the ventilation areas on the sides of the switch module are not blocked.

12.Make sure that the LEDs on the switch module indicate that it is operating correctly. Make sure that:

•When the POST starts, the green OK LED on the switch module is flashing. The POST tests the condition of firmware, memory, data paths, and switch logic and uses the fault LED to indicate pass or fail conditions.

•The green OK LED on the switch module stops flashing to indicate that the switch logic has completed POST.

13.If you have a second switch module to install, repeat step 5 on page 14 through step 12; otherwise, go to step 14.

14.If you are using the external switch-module ports, connect an SFP module option to external Fibre Channel port 0 and Fibre Channel port 15. For SFP

16 Brocade SAN Switch Module: Installation Guide