Configuring your machine for a wireless network

(For MFC-J2510/J4510DW/J4710DW)

a Press .

b Press Wi-Fi.

c Press WPS w/PIN Code.

3

d When Switch Network interface to wireless? is displayed, press Yes to accept. This will start the wireless setup wizard.

To cancel, press No.

e The LCD will show an 8 digit PIN and the machine begins searching for a WLAN access point/router for up to 5 minutes.

f Using a computer that is on the network, type “http://access point’s IP address/” into your browser. (Where “access point’s IP address” is the IP address of the device that is used as the Registrar 1.) Go to the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in e to the Registrar and follow the on-screen instructions.

1The Registrar is normally the WLAN access point/router.

NOTE

The setting page may be different, depending on the brand of WLAN access point/router. See the instruction manual that came with your WLAN access point/router.

If you are using your Windows Vista® or Windows® 7 computer as a Registrar, complete the following steps.

NOTE

To use a Windows Vista® or Windows® 7 computer as a Registrar, you need to register it to your network in advance. See the instruction manual that came with your WLAN access point/router.

1(Windows Vista®)

Click

, Network, and then Add a wireless device.

(Windows® 7)

Click

, Control Panel, Network and Internet, and then

Add a wireless device to the network.

2Choose your machine and click Next.

3Input the PIN from the printed page and then click Next.

4Choose your network that you want to connect to, and then click Next.

5Click Close.

17