Configuring your machine for a wireless network
g A connection result message appears for 60 seconds on the LCD and a wireless LAN report will
automatically be printed. If the connection failed, check the error code on the printed report. See Quick Setup Guide: Troubleshooting
(Windows®) |
|
You have completed the wireless network setup. If you would like to continue installing drivers | 3 |
and software necessary for operating your device, please choose Install |
the
You have completed the wireless network setup. If you would like to continue installing drivers and software necessary for operating your device, please
(For
a Press Settings.
b Press s or t to display Network and then press Network.
c
d to display WPS w/PIN Code, and press WPS w/PIN Code.
e When Network I/F switched to Wireless is displayed, press Yes to accept. This will start the wireless setup wizard.
To cancel, press No.
f The LCD will show an 8 digit PIN and the machine starts searching for a WLAN access point/router for up to 5 minutes.
g Using a computer that is on the network, type “http://access point’s IP address/” into your browser. (Where “access point’s IP address” is the IP address of the device that is used as the Registrar 1.) Go to the WPS
1The Registrar is normally the WLAN access point/router.
NOTE
The setting page may be different, depending on the brand of WLAN access point/router. See the instruction manual that came with your WLAN access point/router.
If you are using your Windows Vista® or Windows® 7 computer as a Registrar, complete the following steps.
NOTE
To use a Windows Vista® or Windows® 7 computer as a Registrar, you need to register it to your network in advance. See the instruction manual that came with your WLAN access point/router.
18