Remote Commands

Follow the commands below to access features remotely. When you call the machine and enter your Remote Access Code (the factory setting is 1 5 9 ), the system will signal you with two short beeps to enter a remote control command.

Change Fax Forwarding Setting

Press 9 5

then to

Turn Fax Forwarding OFF—Press1.

Turn Fax Forwarding ON—Press2.

Program Fax Forward Number—Press4. Automatically turns Fax Forwarding ON. Turn Fax Storage ON—Press6.

Turn Fax Storage OFF—Press 7. (This is only possible if there are no faxes stored in the memory, or if all faxes have been erased using Remote Control 9 6 3).

Retrieve or Erase a Fax

Press 9 6

then to

Retrieve all faxes—Press 2, then enter the number of remote fax machine and then press # #, After the beep, hang up and wait.

Erase all fax messages—Press 3. If the data stored in the memory has not been printed before, it will be printed first and then erased.

Check the Receiving Status

Press 9 7

then Press 1.

1long beep—Received fax messages.

3short beeps—No messages.

Change Receive Mode

Press 9 8

then for

TAD—Press 1.

F/T (FAX/TEL)—Press 2.

FAX—Press 3.

Exit Remote Operation

Press 9 0

52Chapter 9