Brother HL-1060 Series manual Bits, DTR only, Off, 57600 9600

CHAPTER 4 OPTIONS

If necessary, set the serial interface parameters as follows:

1.Make sure that the printer is in the off-line state.

2.Set the serial interface parameters by moving up (on) or down (off) the selectors of the dual in-line package (DIP) switch.

ON

1 2 3 4 5 6 7 8

Fig. 4-2 Setting the Serial Interface Parameters

Table 1: Serial Interface Parameter Settings

Selector	Parameters	On (up)		Off (down)
1	Baud Rate	—	See Table 2.	—
2	Baud Rate	—	See Table 2.	—
3	Data Length	7 bits		8 bits
4	Stop Bit	2 bits		1 bit
5	Parity	—	See Table 3.	—
6	Parity	—	See Table 3.	—
7	Protocol	Xon/Xoff + DTR		DTR only
8	Robust Xon	On		Off
Table 2: Baud Rate Settings
Selector 1	Selector 2	For RS-422A		For RS-232C
Off	Off		57600	9600
On	Off		9600	4800
Off	On		1200	1200
On	On		19200	19200

CHAPTER 4 –3