CHAPTER 9 NOVELL NETWARE PRINTING
Configuring the Brother Print / Fax server (Queue Server Mode in Bindery emulation mode) using PCONSOLE and BRCONFIG
1.Login as Supervisor (NetWare 3.xx) or ADMIN (NetWare 4.1x or later; be sure to specify the /b option for bindery mode).
2.Execute the BRCONFIG from the Windows® menu or insert the "Print / Fax server Configuration Utility diskette in drive A: and type the following at the DOS prompt:
A:BRCONFIG or A:BRCONFIG PrintServerName
Where PrintServerName is the NetWare print service name of the Brother Print / Fax server (the default name is BRN_xxxxxx_P1, where "xxxxxx" is the last six digits of the Ethernet address (MAC address)).
You can find the NetWare print service name and MAC address by printing out the FAX/MFC’s configuration page. Refer to the Quick Network Setup Guide for information on how to print the configuration page on your Print / Fax server.
3.If you did not specify the Print / Fax server name in the BRCONFIG command, select the corresponding server name from the list of Print / Fax servers.
4.When you get the message that the Print / Fax server is connected, type the default password "access" in response to the "#" prompt (the password will not echo), and then press the ENTER key in response to the Enter Username> prompt.
5.When you get the Local> prompt, type:
6.SET NETWARE SERVER servername ENABLED
7.Where servername is the name of the file server on which the print queue will reside. If there is more than one file server that you wish to print from, repeat this command as many times as necessary.