Brother PS-9000 user manual Or Quick Editor, Server. In this case, the IP

Symptom	Cause	Remedy
	If a DHCP/BOOTP server or a
	RARP server resides on the
	network, the IP address is	Create a local environment where the server does
	automatically issued by the
		not exist and issue the IP address to the PS-9000. At
	server. In this case, the IP
		the same time, make sure that “Obtain an IP address
	address that was manually set
		automatically” in the TCP/IP setting is not marked.
	for the PS-9000 may have
The print job is	been overwritten by the
	server.
not printed.
	If the PS-9000 and the
	computer are not in the same	Use the Brother PS-9000 Utility to check whether
	segment, a subnet mask and
		the subnet mask and gateway address are correct.
	gateway address must be set
	for the PS-9000.
		Check the printer port name of the PS-9000. The
		port name is indicated by “(PTLAN xxxxxx: P-touch
		TCP Port)” after the assigned port name.
Dial-up starts	Depending on the operating	When using PS-9000, cancel the setting for
when printing	system being used, the	automatic dial-up or, if the automatic dial-up setting
	automatic dial-up setting may	cannot be cancelled, click [Cancel] in the dialup
is performed.
	have been specified.	dialog box to begin printing.
	If the unit stopped operating
An error	because of a tape width error	After the other user’s print job is finished, try printing
occurs during	or no more tape in the cassette	again. Otherwise, use the Web browser to restart
	during another user’s print job,
printing.		the PS-9000, and then try printing again.
	printing is not possible until
	the error is cancelled.
LPR printing is	With some of the P-touch	With the PT-9200DX, install the printing software
not available	machines, LPR printing is not	for the PS-9000 onto each client, and use it instead
with PS-9000.	available.	of using LPR printing.
The tape width	If PT-9500PC is connected to
	the PS-9000, the tape width
cannot be
	detection function of P-touch
detected by	Editor 4 and Quick Editor does	Manually specify the tape width.
P-touch Editor 4	not operate. (There is no tape
or Quick Editor.	width detection function with
	PT-9200DX.)
		PS-9000 can be initialized (reset to its factory default
Can the PS-9000		settings) by using the Brother PS-9000 Utility.
		Select PS-9000 in the PS-9000 setting dialog box of
be initialized
		the Brother PS-9000 Utility, and then click
(reset to its fac-		[Initialize]. Otherwise, the PS-9000 can be
tory default set-		initialized by pressing the push button. For further
tings)?		information on how to initialize PS-9000 by pressing
		the push button, refer to “Parts and Functions” in
		chapter 1, “About PS-9000”.

29