Control panel setup

Ethernet (wired network only)

Ethernet link mode. Auto allows the print server to operate in 1000BASE-T full duplex (For HL-6180DW(T)), 100BASE-TX full or half duplex, or in 10BASE-T full or half duplex mode by auto negotiation.

Note

If you set this value incorrectly, you may not be able to communicate with your print server.

For details about 1000BASE-T full duplex operation, see Gigabit Ethernet (wired network only) (For HL-6180DW(T))uu page 48.

4

Wired Status

This field displays the current wired network status.

Setup Wizard (wireless network only)

The Setup Wizard guides you through the wireless network configuration. (For more information:

uuQuick Setup Guide or Manual configuration from the control panel uu page 18.)

WPS (Wi-Fi Protected Setup)/AOSS™ (wireless network only)

If your WLAN access point/router supports either WPS (PBC 1) or AOSS™ (Automatic Wireless mode), you can configure the machine easily. (For more information: uu Quick Setup Guide or One push configuration using WPS (Wi-Fi Protected Setup) or AOSS™ uu page 27.)

1Push Button Configuration

WPS (Wi-Fi Protected Setup) w/PIN Code (wireless network only)

If your WLAN access point/router supports WPS (PIN Method), you can configure the machine easily. (For more information, see Configuration using the PIN Method of WPS (Wi-Fi Protected Setup) uu page 29.)

WLAN Status (wireless network only)

Status

This field displays the current wireless network status.

Signal

This field displays the current wireless network signal strength.

38