BT 3505 Between 0 and C until the day and time are set, Telephone wall socket, Talk/Standby time

5675 BT Synergy 3505 UG [4] 11/11/03 4:02 PM Page 8

BT Synergy 3505 – Edition 4 – 11.11.03 – 5675

8	Getting started
	BATTERY LOW WARNING	between 0 and C until the day and time are set.
	If the handset battery symbol is	2. Insert the 2 x AAA NiMH batteries supplied. Then slide
	empty and flashing, and you hear
	a warning beep every minute, you
	will need to recharge your handset
	before you can use it.
	Battery performance
	To keep your batteries in the best
	condition, leave the handset off
	the base for a few hours at a time
	(after the initial 16 hour charge).
	New NiMH batteries do not reach
	full capacity until they have been
	in normal use for several days.
	Running the batteries right down	3. Place the handset on the base to charge for at least 16
	at least once a week will help them	hours. The red Charging light comes on (the red Charging
	last as long as possible.	light stays on even when the batteries are full charged).
	The charge capacity of
		The handset is pre-registered to the base as SYNERGY
	rechargeable batteries will reduce
		HS 1. This is shown on the display. When the handset is
	with time as they wear out, so
	reducing the talk/standby time of	fully charged the display shows a full battery symbol.
	the handset. Eventually they will
	need to be replaced. New	4. After 16 hours, plug one end of the telephone line cord
	batteries can be obtained from the	into your BT Synergy 3505 base and the other end into
	BT Synergy Helpline 0870 605 8047.
		the telephone wall socket.
	Under no circumstances should
	non-rechargeable batteries be
	used. Use only approved Nickel	Talk/Standby time
	Metal Hydride batteries (NiMH)
	size AAA capacity 550mAL 1.2V.	Under ideal conditions, fully charged handset batteries
	Using unapproved batteries will
	invalidate your guarantee and may	should give about 14 hours talk time or 350 hours
	damage the telephone	standby time on a single charge.