Bunn 41343 manual Introduction

INTRODUCTION

The brewer incorporates a wireless interface system that allows the DBC Grinder to load certain information into the "programming chip" located inside the handle of the funnel. This information includes what flavor of coffee is being ground and what batch size will be brewed (small, medium, or large). Once the correct flavor name and amount of coffee is ground, the funnel is loaded into the brewer. The information from the funnel handle is then transferred into the brewer. The brewer then takes this information and dispenses the amount of water preset in the brewer for that particular flavor of coffee and batch size. The brewer can also be programmed to adjust different functions of the brewing process, such as brew temperature, brew volumes, bypass percentages, pulse brew, etc. This allows the operator to program a certain "recipe" for each coffee flavor to be brewed.

TABLE OF CONTENTS
Glossary	4
PROGRAMMING	5
Programming Switches	5
Programming the Brewer	6
PROGRAM FUNCTIONS (LEVEL 1) Brew Lockout	6
PROGRAM FUNCTIONS (LEVEL 2)	8
Units (Setting units of measure)	12
Auto Warmer Shutoff	13
Warmer Control	13
Freshness Time	14
Enable Energy Saver	15
Set New Recipe	16
Using Smart Funnel	16
Using Recipe Card	19
Not Using Smart Funnel or DBC Grinder	20
Review Recipes/Modify Recipes/Set up No Name Coffee	21
Set Brew Volumes	22
Set Bypass Percentages	23
Set Pulse Brew	24
Set Pulse Brew - By Example	26
Set Pulse Brew - Entering Times	27
Set PreInfusion	28
Set Drip Times	29
Enable Ads	30
Set Temp (Brewing Temperature)	30
Set Ready (Ready Temperature)	30
Refill (Adjust Sensitivity)	31
Spray Oz/M (Read sprayhead flow rate)	32
Bypass Oz/M (Read bypass flow rate)	33
Calibrate Flow	34
Calibrate Sprayhead Flow	34
Calibrate Bypass Flow	35
Brew Counters (View/Reset)	36
Funnel Detect	37
Service Tools	37
Test Outputs (Components)	37
Test Switches	39
Test Frequency	40
Factory Defaults (Reset)	40
Page 3
	41343 101911