SERVICE (cont.)
AUGER DRIVE COMPONENTS - FMD-4 & FMD-5 (cont.)
4. Disconnect the dispenser from the power supply.
If voltage is present as described and the auger does not turn, replace the auger motor.
If voltage is not present as described, refer to the wir- ing diagrams and check the dispenser wiring harness.
Removal, Cleaning and Replacement
Hopper & Auger
1.Open the dispenser door and raise the top front cover.
2.Lift the front edge of hopper assy (20) over the tab on hopper support plate (19) and slide hop- per assembly out the front of the dispenser.
3.Remove hopper lid (1) and empty product.
4.Pull off the ejector elbow (13).
5.Remove agitator disc assy (2) by pulling agitator support rod (4) towards agitator disc assy and lifting agitator disc assy from hopper (10).
6.Remove auger (12) by pulling it out the front of the hopper (10).
7.Remove auger drive shaft (5) by removing the retaining clip (6) from auger drive shaft.
8.Slide washer (8) and auger drive shaft bracket
(7)off of the auger drive shaft (5).
9.Slide auger drive shaft (5) from auger drive shaft bushing (3) and remove from hopper (10).
10.Remove locknut (9) from auger drive shaft bush- ing (3) and remove auger drive shaft bushing from hopper (10).
11.Wash components in a mild solution of dish de- tergent using a bristle brush when needed.
12.Rinse and dry each item thoroughly.
13.Check for damaged or broken components, re- place any if necessary and reassemble hopper assy.
14.Install hopper assy (20) in the dispenser by sliding hopper assy in the guides on the hopper support plate (19) until the slot in the bottom rear the hopper seats against the pin (18) in the hopper support plate.
1 |
|
2 |
|
| 4 |
3 | 5 |
8 |
|
7 | 9 |
| |
6 | 10 |
| 11 |
14 15 16 12 13 | P2634 |
| |
FIG. 5 AUGER DRIVE & HOPPER DISASSEMBLY | |
1. | Hopper Lid | 9. | Auger Wire |
2. | Mixing Blade | 10. | Ejector Elbow |
3. | Agitator Disk | 11. | Hopper Assy |
4. | Auger Drive Shaft | 12. Auger Motor Mounting | |
| Bushing |
| Panel |
5. | Auger Drive Shaft | 13. | Hopper Support Plate |
6. | Locknut | 14. | Auger Motor Bracket |
7. | Auger Drive Bracket | 15. | Auger Motor |
8. | Hopper | 16. | Dust Seal |
16 | 35135 012103 |
|
