DRAINING THE HOT WATER TANK
CAUTION - The dispenser must be disconnected from the power source throughout these steps.
1.Disconnect the dispenser from the power source.
2.Place the tank heater switch in the “OFF” position.
3.
4.Remove the front, lower access panel.
5.Pull out drain tube to empty into a sink or a container with a minimum of
6.Make sure drain clamp is closed. Then, remove drain plug.
7.Direct tube into sink or container and open drain clamp. Continue draining tank until ALL of the water is out. WARNING: Be very careful with the draining water because it can be very hot.
8.Close drain clamp, insert drain plug, place drain tube back into machine, and replace lower access panel. NOTE - The dispenser must be refilled using the INITIAL FILL & HEAT steps before reconnecting to the power source.
7 | 35135 012103 |
|
