Bunn FMD-5, FMD-4 service manual Solenoid Valve Cold Water - Optional, SERVICE cont

SERVICE (cont.)

SOLENOID VALVE (COLD WATER - OPTIONAL)

J1

J2

J4

J3

J1

J2

J4

J3

P2635

FIG. 29 COLD WATER SOLENOID VALVE

Location:

The cold water solenoid valve is located on the left side of the dispenser base just behind the compo- nent bracket.

Test Procedures:

1.Disconnect the dispenser from the power source.

2.Disconnect the white and white/yellow wires from the solenoid valve. With the “HOT/COLD” switch in the "COLD" (upper) position press the left dis- pense switch on front of the door.

3.With a voltmeter, check the voltage across the white and white/yellow wires. Connect the dis- penser to the power source. The indication must be:

a)120 volts ac for two wire 120 volt models, three wire 120/208 volt, and 120/240 volt models.

b)240 volts ac for two wire 240 volt models.

4.Disconnect the dispenser from the power source.

If voltage is present as described, proceed to #5

If voltage is not present as described, refer to Wiring Diagrams and check dispenser wiring harness.

5.Check for continuity across the solenoid valve coil terminals.

If continuity is present as described, reconnect the white and white/yellow wires to the solenoid.

If continuity is not present as described, replace the solenoid valve.

6.Check the solenoid valve for coil action. Connect the dispenser to the power source. With "HOT/ COLD" switch in the "COLD" (upper) position press the left dispense switch and listen carefully in the vicinity of the solenoid valve for a "clicking" sound as the coil magnet attracts.

7.Disconnect the dispenser from the power source.

If the sound is heard as described and water will not pass through the solenoid valve, there may be a block- age in the water line before the solenoid valve or, the solenoid valve may require inspection for wear, and removal of waterborne particles.

If the sound is not heard as described, replace the solenoid valve.

Removal and Replacement:

1.Loosen the two screws securing the component bracket to the dispenser base. Lift the component bracket off of the base and move to the right.

2.Remove the white and white/yellow wires from the solenoid valve.

3.Turn off the water supply to the dispenser.

4.Disconnect the water lines to and from the sole- noid valve.

5.Loosen the two #8-32 screws and washers se- curing the solenoid mounting bracket to the base. Remove solenoid bracket and solenoid valve as an assembly.

6.Remove the two #10-32 screws and lockwashers securing the solenoid valve to the solenoid bracket.

7.Using two #10-32 screws and lockwashers install new solenoid valve on solenoid mounting bracket.

8.Install the solenoid valve and bracket on the dis- penser base and tighten the two #8-32 screws.

9.Securely fasten the water lines to and from the solenoid valve.

10.Refer to Fig. 30 when reconnecting the wires.

WHI/YEL to Hot/

Cold Switch

WHI to Main Wiring

Harness

P1215

FIG. 30 COLD WATER SOLENOID TERMINALS

34 35135 012103