PROGRAMMING THE BREWER (cont.)
CALIBRATE FLOW (cont.)
7.Measure the amount of water in the container, and using
8.The display should now read NEW BYPASS FLOW, along with the correct flow rate of the bypass in ounces per minute. After about 5 seconds, the dis- play will return to the CALIBRATE FLOW screen.
9.To exit the CALIBRATE FLOW function, press and release NO to advance to the next function screen, or press the ON/OFF switch located on the front switch panel to exit the CALIBRATE FLOW function and return to the MAIN SCREEN.
BREW COUNTERS
This function allows the operator to track the num- ber of brew cycles completed. There is one resettable counter, and one life counter that is not resettable.
BREW COUNTERS?
NOYES
EXIT TO
NEXT FUNCTION
4.To advance to the other counter, press and release NEXT. This will advance to total brews
5.When finished, press NEXT until the display reads BREW COUNTERS. Press and release NO to ad- vance to the next function screen, or press the ON/OFF switch located on the front switch panel to exit the BREW COUNTERS function and return to the MAIN SCREEN.
FUNNEL DETECT (optional)
This function allows the operator to prevent the start of a brew cycle if a Smart Funnel is not positioned correctly in the funnel rails.
FUNNEL DETECT ?
NO DONE YES
P2721
Procedure to set funnel detect:
1. Press and hold the upper right hidden switch until |
the display reads UNITS. Release the switch, then |
press and release switch until the display reads |
FUNNEL DETECT. |
SCREEN
XXXX
2. NO or YES should be flashing to indicate the cur- |
NEXT RESET
XXXX
NEXT
P2448
Procedures to view/reset the brew counters:
1.Press and hold the upper right hidden switch until the display reads UNITS. Release the switch, then press and release switch until the display reads
BREW COUNTERS.
2.Pressing NO in this screen will advance to the next function. Press YES to view the first brew counter. This number represents the brew cycles initiated since that counter was last reset.
3.To reset the resettable counter to zero press and release RESET when viewing that particular counter's screen.
rent setting. |
3. Select YES to prevent brewing if a Smart Funnel is |
not correctly situated in the rails. If this function is |
activated and a brew cycle is attempted with the |
funnel not properly situated, the display will read, |
FUNNEL NOT IN PLACE, until one is in place. |
4. Select NO to allow brewing without a Smart Fun- |
nel in place. This is selected when brewing with a |
funnel other than a Smart Funnel (a regular brew |
funnel). |
5. When finished, press and release DONE. This will |
retain the changes, exit this function screen and |
advance to the next. Another alternative is to press |
the ON/OFF switch located on the front switch |
panel to exit the FUNNEL DETECT and return to |
the MAIN SCREEN. |
Page 36 | 35879.1 071405 |
|
