Bunn S/N SNG0033000 & UP manual SET Pulse Brew Easy Pulse Setup

PROGRAMMING THE BREWER (cont.)

SET PULSE BREW - EASY PULSE SETUP

NOTE: The procedure to enter the PULSE BREW function must be performed prior to following the steps listed below.

1.The display should read BREW TIME: X.XX and a batch size indicator will be flashing.

2.Using (-) and (+), set the desired brew time for the selected batch size.

3.When finished, select another batch size to be set by pressing the switch next to the indicator light. Repeat step 2 for each batch size to be set.

4.When finished setting all batch sizes, press done. The display should read 3 BATCHES DONE ?.

5.If the three batch sizes are not correct, press and release NO to return to BREW TIME setup screen and repeat steps 2 thru 4. If they are correct, press YES. This will display the 1st, OFF, and LAST times for 5 seconds, then advance to the DRIP TIME setup. (See DRIP TIME SET UP)

		SET PULSE BREW?
		NO		YES
		EASY PULSE SETUP
		NO		YES
ENTER TIMES ?		BREW TIME XX.X
NO	YES	(-)	DONE	(+)
	See SET PULSE BREW-	3 BATCHES DONE?
	ENTER TIMES	NO		YES
		1st	OFF	LAST
		XX.X	XX.X	XX.X
			5 SEC. DELAY
		DRIP TIME XX.X
		(-)	DONE	(+)

3 BATCHES DONE?

NOYES

COFFEE NAME

SETUP COMPLETE

Page 28

P3507

35879.1 071405