PROGRAMMING THE BREWER (cont.)

SET NEW RECIPE

Using a Smart Funnel and a G9-2T DBC or MHG Grinder:

This function allows the operator to set BREW

VOLUMES, BYPASS PERCENTAGES, PULSE BREW TIMES and DRIP-OUT TIMES for each coffee name preset in the grinder's memory.

Certain coffee NAMES are stored in the grinder's memory. When a particular name of coffee is ground into the Smart Funnel, that name and the batch size selected are transferred from the grinder to the pro- gramming chip located in the funnel handle. The funnel is then inserted into the brewer's funnel rails. The sen- sor coil on the brewer reads the information contained in the handle. The name of the coffee flavor will then appear on the display. This allows the operator to set the BREW VOLUMES, BYPASS PERCENTAGES, PULSE BREW TIMES and DRIP-OUT TIMES for that particular coffee NAME. It also allows the operator to set other brewing parameters, such as BREW TEMPERATURE, READY TEMPERATURE, BREW LOCKOUTS, etc. Each coffee NAME can be set individually to provide optimum brewing quality.

SET NEW RECIPE?

NOYES

REVIEW RECIPES?

NOYES

INSERT FUNNEL

WITH NEW NAME

 

 

CYCLES THROUGH

2 SEC.

 

 

TWO SCREENS

QUIT SETUP?

YES

FUNNEL DETECTED

Procedure for Setting the Recipe:

NOTE: Before beginning setup, place a server beneath the brew funnel.

1.Insert the funnel into the grinder and select a batch size to grind. It is not necessary to have coffee beans in the hopper(s) in order to program the brewer. The coffee name is pre-selected and stored in the grinder's memory for the side being ground.

2.Press the GRIND switch. When the grinder stops grinding, remove the funnel.

3.On the brewer, press and hold the upper right hid- den switch until the display reads UNITS. Release the switch, then press and release the switch again until the display reads SET NEW RECIPIE.

4.Press and release YES. The display should read INSERT FUNNEL WITH NEW NAME, then QUIT SETUP? These three displays will repeatedly cycle.

5.Insert the funnel into the rails of the brewer. The display should read the NAME of the coffee that was ground into the funnel, along with a NO and YES. If the NAME on the display is correct, press YES.

6.If, for some reason, the name of the coffee from the grinder did not load properly into the funnel, or if a grind has not yet been done, the display will read MUST GRIND INTO FUNNEL FIRST. It will be necessary to grind another batch following steps 1 and 2.

7.If the grind is acknowledged by the brewer, the display will read BEGIN SETUP OF (COFFEE NAME). Then the screen will display BREW OZ. and a batch light will be blinking. (Refer to BREW OZ. SETTING OR ADJUSTING for description).

FUNNEL

 

FUNNEL CONTAINS

 

CONTAINS NAME

 

 

 

NO NAME

 

(COFFEE NAME)

NOYES

BEGIN SETUP OF (COFFEE NAME)

 

SETUP BREW VOLUMES, BYPASS, PULSE BREW,

 

PREINFUSION, DRIPOUT TIME

3 BATCHES DONE?

NO

YES

MUST GRIND INTO

FUNNEL FIRST

SEE SEPARATE DIAGRAMS

FOR SETUP INSTRUCTIONS

BREW OZ. XX.X

(-)

DONE

(+)

3 BATCHES DONE?

NO

 

YES

(COFFEE NAME)

 

SETUP COMPLETE

P2439

 

Page 19

% BYPASS XX.X

(-)

DONE

(+)

P2415

35879.1 071405

Page 19
Image 19
Bunn S/N SNG0033000 & UP SET NEW Recipe, This function allows the operator to set Brew, Procedure for Setting the Recipe